Datalogic DM3610, Reference Manual, Page: 118 / 157

TWO-HEAD DIMENSIONING SYSTEM REFERENCE MANUAL
108
5
5.2 ADJUST THE TILT AND SKEW OF THE DM3610 DIMENSIONERS
When the equipment and cabling has been installed as described in
chapters 2 (Mechanical
Installation) and 3 (Electrical Installation), apply power to the system.
5.2.1 Adjust the Tilt
1. With the DM3610 dimensioners powered up and the lasers active, set the largest test box
(see Calibration Kit in Two-Head Dimensioning Reference Manual, Chapter 1
Introduction) perpendicular to the conveyor with its edge even with the edge of the
conveyor.
2. While keeping the test box aligned with the conveyor, adjust its position until the laser is
just touching the edge of the box. The goal is to adjust the alignment of the DM3610 until
the laser is parallel to the edge of the test box.
Figure 50: Adjusting the Tilt
TOP VIEW
Test Box
Laser should
be parallel with
the edge of the
box.
Beam Catcher
Direction of
Travel