Datalogic DM3610, Reference Manual, Page: 35 / 157

MECHANICAL INSTALLATION
25
2
2.4.12 Pre-Configuring the DM3610 Dimensioners
When preparing the DM3610 dimensioners for a multi-head dimensioning system, several
parameters must be changed, including the default IP address. All DM3610 dimensioners are
defaulted to an IP address of 198.168.3.100. Since your multi-head dimensioning system will
have more than one dimensioner, the IP addresses must be changed before connecting to
the network to avoid IP address conflicts. Each DM3610 must have a unique IP address.
Also, in a multi-head system, dimensioners are numbered from left to right. The left most
head facing downstream is named
HEAD1 , followed by HEAD2 , and etc.
To change the DM3610 parameters and mount the dimensioner (repeat for each system
dimensioner):
1. Plug the dimensioners in using the power supplies provided.
2.
You must configure your PC’s IP Address to be in the same network as the DM3610’s
IP Address (example: 192.168.3.1). Set the Netmask to 255.255.255.0 and the
Gateway to 0.0.0.0.
Connect your laptop computer to the DM3610 HOST port using either the CAB-ETH-
M0x M12-IP67 ETHERNET CABLE or CBL-1534-0.2 ADAPT.CABLE ETH M12-TO-
RJ45F.
3. Open a browser on the laptop computer, and type in the default IP address of
198.168.3.100. The DM3610 User Interface opens in the browser window.
NOTE:
Details on using the DM3610 User Interface are
available in the DM3610 Dimensioner Reference Manual ,
Chapter 4 .
4. Log on to the user interface. The default User ID is DM3610, and default Password is
DM3610.