dallmeier DLS 24 S1, Installation And Configuration Manual

Page: 153 / 215

153 Dallmeier electronic GmbH & Co.KG
17.2.4 Functions
Function Description
Keine No function selected.
MenuExit The currently displayed menu of the
„
old“ GUI is closed.
TrackAStart Recording of all defined cameras on track A is strated.
TrackBStart Recording of all defined cameras on track B is started.
TrackCStart Recording of all defined cameras on track C is started.
TrackSStart Recording of all defined cameras on track S is started.
ContRecStopG All active contact recordings are stopped. This affects all
cameras with contact recording on any track.
Shut down recorder The recorder will be shut down without taking further conditions
into account.
Start alarm This function activates the alarm state of the recorder. The
alarm duration can be set via Setup > System > Options >
Alarm Duration.
Stop alarm The recorder is in alarm state. The contact function Stop
alarm allows the alarm to be stopped before the end of the
alarm duration.
After stopping the alarm state, the secure tracks are saved
and new secure tracks created. The tracks are locked and
must be released separately.
RecToggleG Recording starts when the contact is actuated. Recording stops
when the contact is released.
Protect Secure-Tracks Active recording into the secure tracks is stopped. The secure
(all) tracks are saved. Recording is continued in new secure
tracks.
TrackSSaveMode Activation of single-track saving of a camera for 5 seconds. If
camera contact occurs within the next 5 seconds, the
corresponding track is saved.
Activate Sequencer The recorder will automatically switch to sequencer / live-
mode, 1x1 split. If cameras are defined for sequencer mode
their live images will be displayed one after another.
RecStartG Recording is started globally (from Standby).
RecStopG Recording is stopped globally (from Standby).
Extend alarm The recorder is in alarm state. If the Extend alarm contact
function is triggered before the end of the alarm duration, the
alarm state will be extended indefinitely (or until the
corresponding track is full).
The alarm state can then only be stopped by the Stop alarm
contact function.