9
IMPORTANT
• Use of the back-up battery is often compulsory for operation with a transmission module (see chapter 2.6 Power supply).
• the back-up battery is recharged on the control panel and is designed to back up the main power supply.
• Connect the back-up battery before the lithium power pack or internal mains power module.
• The back-up battery must be connected with the power off.
2.6.1 When using the lithium power pack (supplied)
1.
Position the lithium power pack on
the guide rails.
2.
Slide the lithium power pack to the
top until it locks into position.
3.
After power-up you will hear the
control panel voice message:
To remove the lithium power pack,
press on the unlocking key and slide
it downwards.
IMPORTANT
• If the dialler does not respond as it
should:
- disconnect the lithium power pack
and then the back-up battery,
- wait for 2 min,
- reconnect the back-up battery
and then the lithium power pack,
- check the correct voice message
is issued.
If there is a problem, the control
panel will issue the following
message:
“Fault, battery voltage,
control panel”
.
• On power-up, the control panel is
automatically in installation mode.
“bip, installation mode”
Locking key
2.6.2 When using the BatLi 22 lithium power pack and the Li-Ion rechargeable back-up battery
1.
Connect the rechargeable back-up battery
to the 2-point connector.
2.
Clip the back-up battery into its compartment.
3.
Position the lithium power pack on
the guide rails.
4.
Slide the lithium power pack to the
top until it locks into position.
5.
After power-up you will hear the
control panel voice message:
To remove the lithium power pack, press on the unlocking key and slide it downwards.
IMPORTANT
• If the dialler does not respond as it
should:
- disconnect the lithium power pack
and then the back-up battery,
- wait for 2 min,
- reconnect the back-up battery
and then the lithium power pack,
- check the correct voice message
is issued.
If there is a problem, the control
panel will issue one of the fault
messages (see Indication of power
faults on power-up on previous
page).
• On power-up, the control panel is
automatically in installation mode.
“bip, installation mode”
3.7 V/1.2 Ah
back-up
battery
2-point
connector
Locking key