31
8.4 Fixing the control panel in place
A
45°
For insertion of
lithium power
Cable clamp
Tamper pin
INSTALLATIO
N
MODE
1.
Remove the tamper washer located on the
back of the base.
2.
• To be able to install the control panel, there must be a clearance
of 5 cm to the left and 3 cm on top of the base to allow for the
hinge and a clearance of 18 cm below the base to open or lock
the control panel.
2.
• Fix the base at the 3 points using suitable plugs and screws.
4.
Thread each cable through the cable trough in the base and
remove the pre-cut parts for cable insertion at the bottom of the
base.
5.
Position the cable clamp and tighten the cables enough so that
they do not move when pulled (the cable clamp and screws are in
the bag of accessories provided).
Detachable
tamper washer
Pozidriv 2
Pozidriv 2
3.
Position the control panel open at 45 ° (
A
)
in relation to the base and place the base
hinge pins inside the hinges.
Tamper hole with washer (
A
)
Detachable tamper
washer
Fixing holes without washer
5 cm
18 cm
wall
3 cm
45°
A
• Make sure there are no wires blocking the power pack
compartment in the base and that the cover can be closed.
• Tighten the cables enough so that they do not move when pulled.