151
DWS-1008 User’s Manual
D-Link Systems, Inc.
Configuring DWL-8220AP Access Points
Displaying Status Information for APs Configured by the Template
To display status information for APs configured by the template, type the following
command:
DWS-1008#
show dap status auto
Dap: 100 (auto), IP-addr: 10.8.255.6 (vlan ‘default’), AP model: DWL-8220AP,
manufacturer: D-Link, name: AP100
====================================================
State: operational (not encrypted)
CPU info: IBM:PPC speed=266666664 Hz version=405GPr
id= ram=33554432
s/n=0333703027 hw_rev=A3
Uptime: 18 hours, 36 minutes, 27 seconds
Radio 1 type: 802.11g, state: configure succeed [Enabled] (802.11b protect)
operational channel: 1 operational power: 14
base mac: 00:0b:0e:00:d2:c0
bssid1: 00:0b:0e:00:d2:c0, ssid: public
bssid2: 00:0b:0e:00:d2:c2, ssid: employee-net
bssid3: 00:0b:0e:00:d2:c4, ssid: mycorp-tkip
Radio 2 type: 802.11a, state: configure succeed [Enabled]
operational channel: 64 operational power: 14
base mac: 00:0b:0e:00:d2:c1
bssid1: 00:0b:0e:00:d2:c1, ssid: public
bssid2: 00:0b:0e:00:d2:c3, ssid: employee-net
bssid3: 00:0b:0e:00:d2:c5, ssid: mycorp-tkip
The output displays
auto
next to the Distributed AP number to indicate that the AP was
configured using a template.
Converting a DWL-8220AP Configured by the Template into a Permanent
AP
You can convert a temporary AP configuration created by the template into a persistent AP
configuration on the switch. To do so, use the following command:
set
dap
auto
persistent
{
dap-num
|
all
}
This command creates a persistent Distributed AP configuration based on the settings in the
template. The Distributed AP name and number assigned by the template are used for the
persistent entry. For example, if the template assigned the number 100 and the name AP100
to the AP, the persistent configuration for the AP has the same number and name. In this
case, use
100
as the
dap-num
with
show dap
,
set dap
, or
clear dap
commands.
The AP continues to operate without interruption after you enter the
set dap auto persistent
command. The next time the AP is restarted, the template is not used to configure the AP.
Instead, the persistent configuration is used. (Use the
save config
command to make the AP
configuration persistent across switch restarts.)
Summary of Contents for DWS-1008
Page 1: ......
