DGS-3312SR Layer 3 Gigabit Switch
24
5
S
WITCH
P
ORT
C
OMMANDS
The switch port commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config ports
[<portlist | all> {speed [auto | 10_half | 10_full | 100_half | 100_full |
1000_full {[master | slave]}} | flow_control [enable | disable] |
learning [enable | disable] | state [enable | disable] description
<desc 32> | clear]}
show ports
{<portlist>} {description}
Each command is listed, in detail, in the following sections.
NOTE:
As a stand-alone switch or as a master switch in a switch stack,
the switch number will be referred to as 15 for all configurations, graphs
and tables.
config ports
Purpose
Used to configure the Switch’s Ethernet port settings.
Syntax
[<portlist | all> {speed [auto | 10_half | 10_full | 100_half |
100_full | 1000_full{[master | slave]}} | flow_control [enable |
disable] | learning [enable | disable] state [enable | disable]
description <desc 32> | clear]}
Description
This command allows for the configuration of the switch’s Ethernet
ports. Only the ports listed in the
<portlist>
will be affected.
Parameters
<portlist>
−
Specifies a range of ports to be configured. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4
−
in numerical order.
all
−
Configure all ports on the switch.
auto
−
Enables auto-negotiation for the specified range of ports.
[10 | 100 | 1000]
−
Configures the speed in Mbps for the specified
range of ports.
[half | full]
−
Configures the specified range of ports as either full-
or half-duplex.
{[master | slave}]
−
Configures the specified range of ports as
either master or slave ports.