DGS-3312SR Layer 3 Gigabit Switch
134
To disable MAC notification without changing basic configuration:
DGS-3312SR:4#disable mac_notification
Command: disable mac_notification
Success.
DGS-3312SR:4#
config mac_notification
Purpose
Used to configure MAC address notification.
Syntax
config mac_notification {interval <int 1-2147483647> |
historysize <int 1-500>
Description
MAC address notification is used to monitor MAC addresses
learned and entered into the FDB.
Parameters
interval <int 1-2147483647>
- The time in seconds between
notifications. The user may choose an interval between 1 and
2,147,483,647 seconds.
historysize <1 - 500>
- The maximum number of entries listed in the
history log used for notification.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure the switch’s MAC address table notification global settings:
DGS-3312SR:4#config mac_notification interval 1 historysize 500
Command: config mac_notification interval 1 historysize 500
Success.
DGS-3312SR:4#
config mac_notification ports
Purpose
Used to configure MAC address notification status settings.
Syntax
config mac_notification ports [<portlist | all] [enable | disable]
Description
MAC address notification is used to monitor MAC addresses learned
and entered into the FDB.
Parameters
<portlist>
- Specify a port or range of ports to be configured. The port
list is specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-
2:4 specifies all of the ports between switch 1, port 3 and switch 2,
port 4
−
in numerical order.
all
– Entering this command will set all ports on the system.
