DGS-3312SR Layer 3 Gigabit Switch
227
32
R
OUTING
T
ABLE
C
OMMANDS
The routing table commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
create iproute
<network_address> <ipaddr> {<metric 1-65535>} {[primary |
backup]}
create iproute default
<ipaddr> {<metric 1-65535>}
delete iproute default
delete iproute
<network_address> <ipaddr> {[primary | backup]}
show iproute
{<network_address>} {[static | rip | ospf]}
Each command is listed, in detail, in the following sections.
create iproute
Purpose
Used to create IP route entries to the switch’s IP routing table.
Syntax
create iproute <network_address> <ipaddr> {<metric 1-
65535>} {[primary | backup]}
Description
This command is used to create a primary and backup IP route
entry to the switch’s IP routing table.
Parameters
<network_address>
−
IP address and netmask of the IP interface
that is the destination of the route. You can specify the address
and mask information using the traditional format (for example,
10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8).
<ipaddr>
−
The gateway IP address for the next hop router.
<metric 1-65535>
−
Allows the entry of a routing protocol metric
entry, representing the number of routers between the Switch and
the IP address above. The default setting is 1.
[primary | backup]
- The user may choose between
Primary
and
Backup.
If the Primary Static/Default Route fails, the Backup
Route will support the entry. Please take note that the Primary
and Backup entries cannot have the same Gateway.
Restrictions Only
administrator-level users can issue this command.
Example Usage:
To add a single static address 10.48.74.121, mask 255.0.0.0 and gateway 10.1.1.254 to the routing table:
DGS-3312SR:4#create iproute 10.48.74.121/255.0.0.0 10.1.1.254 1
Command: create iproute 10.48.74.121/8 10.1.1.254 1
Success.
DGS-3312SR:4#
