DGS-3312SR Layer 3 Gigabit Switch
90
To configure traffic control and enable broadcast storm control system wide:
DGS-3312SR:4#config traffic control all broadcast enable
Command: config traffic control all broadcast enable
Success.
DGS-3312SR:4#
show traffic control
Purpose
Used to display current traffic control settings.
Syntax
show traffic control {group_list <storm_grouplist>}
Description
This command displays the current storm traffic control
configuration on the switch.
Parameters
group_list <storm_grouplist>
−
Used to specify a broadcast storm
control group. This is specified by listing the lowest switch number
and the beginning port number on that switch, separated by a
colon. Then the highest switch number, and the highest port
number of the range (also separated by a colon) are specified.
The beginning and end of the port list range are separated by a
dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports
between switch 1, port 3 and switch 2, port 4
−
in numerical order.
Restrictions None.
Example usage:
To display traffic control setting:
DGS-3312SR:4#show traffic control 1:1-1:5
Command: show traffic control 1:1-1:5
Traffic Control
Broadcast Multicast Destination
Module Group [ports] Threshold Storm Storm Lookup Fail
------ ------------- --------- --------- --------- --------
1 1 [ 1 ] 128 Disabled Disabled Disabled
1 2 [ 2 ] 128 Disabled Disabled Disabled
1 3 [ 3 ] 128 Disabled Disabled Disabled
1 4 [ 4 ] 128 Disabled Disabled Disabled
1 5 [ 5 ] 128 Disabled Disabled Disabled
Total Entries: 5
DGS-3312SR:4#
