DGS-3312SR Layer 3 Gigabit Switch
106
config vlan
forbidden
−
Specifies the ports as forbidden ports.
delete
−
Used to delete ports from the specified VLAN, in
conjunction with the
portlist
parameter.
<portlist>
−
A range of ports to add to the VLAN. The port list is
specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end
of the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3
and switch 2, port 4
−
in numerical order.
advertisement [enable | disable ]
−
Enables or disables GVRP on
the specified VLAN.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To add 4 through 8 of module 2 as tagged ports to the VLAN v1:
DGS-3312SR:4#config vlan v1 add tagged 2:4-2:8
Command: config vlan v1 add tagged 2:4-2:8
Success.
DGS-3312SR:4#
config gvrp
Purpose
Used to configure GVRP on the switch.
Syntax
config gvrp [<portlist> | all] {state [enable | disable] |
ingress_checking [enable | disable] | acceptable_frame
[tagged_only | admit_all] | pvid <vlanid 1-4094>}
Description
This command is used to configure the Group VLAN Registration
Protocol on the switch. You can configure ingress checking, the
sending and receiving of GVRP information, and the Port VLAN ID
(PVID).
Parameters
<portlist>
−
A range of ports for which you want ingress checking.
The port list is specified by listing the lowest switch number and
the beginning port number on that switch, separated by a colon.
Then the highest switch number, and the highest port number of
the range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4
−
in numerical order.
all
−
Specifies all of the ports on the switch.
