DGS-3312SR Layer 3 Gigabit Switch
237
34
BOOTP R
ELAY
C
OMMANDS
The BOOTP relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config bootp_relay
{hops <value 1-16> | time <sec 0-65535>}
config bootp_relay add ipif
<ipif_name 12> <ipaddr>
config bootp_relay delete ipif
<ipif_name 12> <ipaddr>
enable bootp_relay
disable bootp_relay
show bootp_relay
{ipif <ipif_name 12>}
Each command is listed, in detail, in the following sections.
config bootp_relay
Purpose
Used to configure the BOOTP relay feature of the switch.
Syntax
config bootp_relay {hops <value 1-16>} {time <sec 0-
65535>}
Description
This command is used to configure the BOOTP relay feature.
Parameters
hops <value 1-16>
−
Specifies the maximum number of relay
agent hops that the BOOTP packets can cross.
time <sec 0-65535>
−
If this time is exceeded, the switch will
relay the BOOTP packet.
Restrictions Only
administrator-level users can issue this command.
Example Usage:
To configure bootp relay status.
DGS-3312SR:4#config bootp_relay hops 4 time 2
Command: config bootp_relay hops 4 time 2
Success.
DGS-3312SR:4#
