DGS-3312SR Layer 3 Gigabit Switch
241
35
DNS R
ELAY
C
OMMANDS
The DNS relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config dnsr
{[primary | secondary] nameserver <ipaddr> | [add | delete]
static <domain_name 32> <ipaddr>}
enable dnsr
{cache | static}
disable dnsr
{cache | static}
show dnsr
{static}
Each command is listed, in detail, in the following sections.
config dnsr
Purpose
Used to configure the DNS relay function.
Syntax
config dnsr {[primary | secondary] nameserver <ipaddr> |
[add | delete] static <domain_name 32> <ipaddr>}
Description
This command is used to configure the DNS relay function on
the switch.
Parameters
primary
−
Indicates that the IP address below is the address of
the primary DNS server.
secondary
−
Indicates that the IP address below is the address
of the secondary DNS server.
nameserver <ipaddr>
−
The IP address of the DNS nameserver.
[add | delete]
– Indicates if the user wishes to add or delete the
DNS relay function.
<domain_name 32>
−
The domain name of the entry.
<ipaddr>
−
The IP address of the entry.
Restrictions Only
administrator-level users can issue this command.
Example Usage:
To set IP address 10.43.21.12 of primary.
DGS-3312SR:4#config dnsr primary 10.43.21.12
Command: config dnsr primary 10.43.21.12
Success
DGS-3312SR:4#
Example Usage:
To add an entry domain name dns1, IP address 10.43.21.12 to DNS static table:
