DGS-3312SR Layer 3 Gigabit Switch
272
Usage Example
To configure the OSPF area aggregation settings:
DGS-3312SR:4#config ospf aggregation 10.1.1.1 10.48.76.122/16
lsdb_type summary advertise enable
Command: config ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type
summary advertise enable
Success.
DGS-3312SR:4#
show ospf aggregation
Purpose
Used to display the current OSPF area aggregation settings.
Syntax
show ospf aggregation {<area_id>}
Description
This command will display the current OSPF area aggregation
settings.
Parameters
<area_id>
−
Enter this parameter if you wish to view this table by
a specific OSPF area ID.
Restrictions None.
Usage Example
To display OSPF area aggregation settings:
DGS-3312SR:4#show ospf aggregation
Command: show ospf aggregation
OSPF Area Aggregation Settings
Area ID Aggregated LSDB Advertise
Network Address Type
------------ --------------------- -------------- -------------
10.1.1.1 10.0.0.0/8 Summary Enabled
10.1.1.1 20.2.0.0/16 Summary Enabled
Total Entries: 2
DGS-3312SR:4#
show ospf lsdb
Purpose
Used to display the OSPF Link State Database (LSDB).
Syntax
show ospf lsdb {area_id <area_id> | advertise_router
<ipaddr> | type [rtrlink | netlink | summary | assummary |
asextlink]}
Description
This command will display the current OSPF Link State Database
(LSDB).
Parameters
area_id <area_id>
−
A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
