DGS-3312SR Layer 3 Gigabit Switch
92
Command Parameters
show 802.1p default_priority
{<portlist>}
config scheduling_mechanism
[strict | round_robin]
show scheduling_mechanism
Each command is listed, in detail, in the following sections.
config bandwidth_control
Purpose
Used to configure bandwidth control on a by-port basis.
Syntax
config bandwidth_control [<portlist> | all] {rx_rate [no_limit |
<value 1-1000>] | tx_rate [no_limit | <value 1-1000>]}
Description
The
config bandwidth_control
command is used to configure
bandwidth on a by-port basis.
Parameters
<portlist>
−
Specifies a range of ports to be configured. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon.
Then the highest switch number, and the highest port number of
the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a dash.
For example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4
−
in numerical order.
all
– Choose this parameter to select all configurable ports.
rx_rate
−
Specifies that one of the parameters below (
no_limit
or
<value 1-1000>
) will be applied to the rate at which the above
specified ports will be allowed to receive packets
no_limit
−
Specifies that there will be no limit on the rate
of packets received by the above specified ports.
<value 1-1000>
−
Specifies the packet limit, in Mbps, that
the above ports will be allowed to receive.
tx_rate
−
Specifies that one of the parameters below (
no_limit
or
<value 1-1000>
) will be applied to the rate at which the above
specified ports will be allowed to transmit packets.
no_limit
−
Specifies that there will be no limit on the rate
of packets received by the above specified ports.
<value 1-1000>
−
Specifies the packet limit, in Mbps, that
the above ports will be allowed to receive.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure bandwidth control:
DGS-3312SR:4#config bandwidth_control 1:1-1:10 tx_rate 10
Command: config bandwidth_control 1:1-1:10 tx_rate 10
Success.
DGS-3312SR:4#