DGS-3312SR Layer 3 Gigabit Switch
177
Example usage:
To display the 802.1x authentication states (stacking disabled):
DGS-3312SR:4#show 802.1x auth_configuration ports 1
Command: show 802.1x auth_configuration ports 1
802.1X : Enabled
Authentication Mode : None
Authentication Protocol : Radius_EAP
Port number : 1:1
Capability : None
AdminCrlDir : Both
OpenCrlDir : Both
Port Control : Auto
QuietPeriod : 60 sec
TxPeriod : 30 sec
SuppTimeout : 30 sec
ServerTimeout : 30 sec
MaxReq : 2 times
ReAuthPeriod : 3600 sec
ReAuthenticate : Disabled
CTRL+C
ESC
q
Quit
SPACE
n
Next Page
Enter
Next Entry
a
All
show 802.1x auth_state
Purpose
Used to display the current authentication state of the 802.1x server
on the switch.
Syntax
show 802.1x auth_state {ports [<portlist>}
Description
The
show 802.1x auth_state
command is used to display the
current authentication state of the 802.1x Port-based Network
Access Control server application on the switch.
Parameters
ports <portlist>
−
Specifies a range of ports. The port list is specified
by listing the lowest switch number and the beginning port number
on that switch, separated by a colon. Then highest switch number,
and the highest port number of the range (also separated by a
colon) are specified. The beginning and end of the port list range are
separated by a dash. For example, 3 would specify port 3. 4
specifies port 4. 3-4
specifies all of the ports between port 3 and port
4
−
in numerical order.
The following details what is displayed:
Port number
−
Shows the physical port number on the switch.
Auth PAE State: Initialize / Disconnected / Connecting /
Authenticating / Authenticated / Held / ForceAuth / ForceUnauth
−
Shows the current state of the Authenticator PAE.
Backend State: Request / Response / Fail / Idle / Initialize / Success
/ Timeout
−
Shows the current state of the Backend Authenticator.
Port Status: Authorized / Unauthorized
−
Shows the result of the
authentication process. Authorized means that the user was
authenticated, and can access the network. Unauthorized means
that the user was not authenticated, and cannot access the network.
Restrictions Only
administrator-level users can issue this command.