CynkoMet RS-1500, Instructions For Use And Operation

Page: 44 / 101

Cynko Met
RS-1500
44
Table 6. Orientational tightening torques for screws
Metric thread
Screw class
5.8 8.8 10.9
Nm
M6 5 7 11
M8 12 18 26
M10 23 35 52
M12 40 60 89
M14 64 98 144
M16 95 145 213
M18 133 209 297
M20 186 292 416
M22 247 389 553
M24 320 502 715
M27 464 729 1,039
M30 634 997 1,420
6.1 Regulation of driving wheel bearings backlash.
After driving the first 100 km and after every 1500-2000 km after that - check, and if
necessary adjust, the backlash of the wheel bearings.
In order to check backlash:
•
raise the wheel of the spreader intended for backlash adjustment,
•
by slowly turning the wheel, check whether motion is fluid and the wheel turns
without excessive resistance and jamming - if this is not the case, replace the bearing,
•
by gripping the top of the tire with one hand and the bottom of the tire with the
other and deflecting both ends from vertically in an alternating fashion, check whether
the wheel has any noticeable backlash,
•
if the wheel’s deflection is greater than just barely perceptible, adjust backlash.
Adjustment of backlash:
•
dismount the hub cap by levering it out in several places around the circumference