CynkoMet RS-1500, Instructions For Use And Operation

Page: 36 / 101

Cynko Met
RS-1500
36
4.3.4 Connecting and disconnecting with the tractor.
The spreader can be connected to the agricultural tractor, if all connections
(electrical, pneumatic, hydraulic), and the hook in the agricultural tractor comply with
the requirements of the manufacturer of the spreader and the tractor. In the case
where the spreader is equipped with a turning hitch, one should remember that it is
adapted to the three-point hitch of class 2 tractors.
In order to connect the spreader to the tractor, perform the following steps:
•
check whether chocks are placed under the spreader’s wheels.
•
set the drawbar at the height of the tractor's transport hitch/lower suspension points
by adjusting the drawbar’s bracket.
•
reversing the tractor, couple the end of the drawbar to the proper transport
hitch/lower suspension points on the tractor.
•
stop the tractor engine and remove the key from the ignition.
•
install and secure the hitch swivel from falling out or check the locking of the
automatic hitch.
• connect cables and hoses of the electrical and hydraulic systems to the tractor
according to the instructions.
NOTE!
NOTE!
At the time of the coupling, unauthorized people cannot be
between the spreader and the tractor. The operator of the
tractor, when connecting the machine should be particularly
careful when working and make sure that in the course of
coupling, other people are not in the danger zone.
NOTE!
NOTE!
When connecting the hydraulic hoses to the tractor, pay
attention that the hydraulic system of the tractor is not under
pressure.
NOTE!
NOTE!
When
coupling ensure adequate visibility.
If the case of restricting visibility, use the sound signal from the
tractor or use the help of another person.