CynkoMet RS-1500, Instructions For Use And Operation

Page: 31 / 101

Cynko Met
RS-1500
31
Figure 11. Adjustable bracket (from the left: isometry, side projection)
1. Bracket raising lever;
2. Wheels up position – “drive”;
3. Wheels down position – “park”;
• pull the wedges from under the wheels of the spreader.
•
set travel speed (fig. 11). Remember that only the first 3 holes for unloading (item 3,
fig. 11) serve for spreading. The last two holes, with the greatest speed, serve for
unloading when the spreader is set up for work as a self-dumping transporter.
•
Start the tractor.
•
move the whole set by a few meters.
•
engage PTO revolutions - revolutions of the ada pter's drums and conveyor’s feed
rate.
•
in the event of improper feeder feed rate, set the adjusting lever to the proper
position (fig. 12). Feed rate is changed by switching the lever from neutral position
(item 2, fig. 12)
– the closest holes (item A, fig. 12) correspond to the lowest speed,
and the farthest - the highest speed (item B, fig. 12).
1.
3.
2.