CynkoMet RS-1500, Instructions For Use And Operation

Page: 55 / 101

Cynko Met
RS-1500
55
Figure 19. Lubricating the spreader
Before commencing the lubrication of the grease fitting, the greased surfaces
and places nearby lubrication points must be thoroughly cleaned of mud and dust.
The grease should be injected in the grease fitting until release of fresh grease in the
gaps between the mating parts.
The oil with which the transmission box is filled is to be replaced after the first 20
hours of work, then after every 100 hours of work. Check and maintain the minimum
oil level in the transmission.
To change oil:
•
The drain plug (item 1, fig. 20) found at the bottom of the body serves to
remove oil. Oil from the transmission box is to be removed immediately after
the machine’s operation, when the oil is hot, into the container intended for this
purpose.
•
The vent hole (item 2, fig. 20) situated at the top of the body serves for filling of
the transmission box with oil.
•
The proper oil level can be assessed when the spreader is in horizontal position
by means of the oil level indicator window (item 3, fig. 20), which is found in the
mount of bearings.
• The indispensable amount of oil is 1.6l.
•
Before replacing the drain plug, clean it of contaminants.
Lubrication
frequency
Points
Every 10h of
work
5, 6
Every half year 2, 3, 7, 10
Every year
1, 8, 9, 11
Every 100h of
work
4
Name of
grease
Standard Symbol
ŁT 43 PN/C-96134
AGROL U oil PN/C-96100