CynkoMet RS-1500, Instructions For Use And Operation

Page: 41 / 101

Cynko Met
RS-1500
41
NOTE!
NOTE!
Before driving, make sure that:
•
the spreader hydraulic system is connected to the tractor and
works properly
•
the spreader’s electric installation is connected to the tractor
and works properly
•
all the elements of the spreader are in good general condition
(no mechanical defects)
•
Do not exceed the maximum designed speed. Travel speed must be adapted to the
prevailing conditions, machine load, type of cargo and other conditions.
•
The lighting and signaling installation should be kept clean and it is advised to take
care of its technical condition.
•
Damaged or lost lighting and signaling elements are to be immediately repaired or
replaced.
•
Avoid ruts, depressions, ditches or driving on shoulders of the road. Driving through
such obstacles can cause sudden tilting of the spreader and tractor. This is particularly
important because the center of gravity of the loaded spreader adversely affects
driving safety. Driving near the edge of ditches or canals is dangerous because of the
risk of landslides under the wheels of the spreader or tractor.
•
The driving speed must be reduced sufficiently in advance before approaching turns
or unevennesses and inclines in the terrain.
•
When driving avoid sharp corners, especially on slopes.
•
Please note that the braking path of the set increases significantly as the weight of
the carried cargo increases and as speed increases.
•
Control the behavior of the spreader while driving on uneven terrain, and adjust the
speed to terrain and traffic conditions.
•
The spreader is adapted for driving on slopes of maximally up to 8 o . Moving the
spreader over steeper slopes may cause the machine to tip over.
•
When driving down slopes with a loaded spreader, speed must be reduced.