96
Note:
The Z-Wave LED turns blinking green when clicking Add Node, Remove Node, Remove Failed
Node or Replace Failed Node. The Z-Wave LED turns off when clicking Initiate or Reset.
If this controller is the primary controller for your network, resetting it will result in the nodes in your
network being orphaned and it will be necessary after the reset to exclude and re-include all of the
nodes in the network. If this controller is being used as a secondary controller in the network, use this
procedure to reset this controller only in the event that the network primary controller is missing or
otherwise inoperable.
3.8.1.1 Adding and Removing The Controller in An Existing Network
To add the controller to an existing network:
1. Click
“Initiate”
to activate Learn Mode.
2. Wait for inclusion request from another controller.
3. Once the controller is successfully included, the Learn Mode stops.
To remove the controller from an existing network:
1. Click
“Initiate”
to activate Learn Mode.
2. Wait for exclusion request from another controller.
3. Once the controller is successfully excluded, the Learn Mode stops.
Note:
Make sure that the controller did not include any other device before, otherwise the controller
will not be able to access Learn Mode and the Initiate button will become invalid.
3.8.1.2 How to Initiate A Replication of Network Information from The Controller
to Another Controller
1. Click “Add Node” to include a controller into our network.
2. Turn the other controller into “Learn Mode”.
