45
ICPE(config)# vlan dot1q-vlan
Globally enable 802.1q VLAN.
ICPE(config)# vlan dot1q-vlan [1-
4094]
[1-4094]
Enter a VID number to create a 802.1q
VLAN.
Note :
802.1q VLAN ID need to be created
under interface global command. In
here you can only modify it instead
of creating a new VLAN ID.
ICPE(config)# vlan dot1q-vlan
isolation
Enable VLAN isolation mode. When
enabled, each LAN port is separated
and can not communicate with each
other except for forwarding packets to
port 6 (WAN port).
In other words, the device will be
forced to follow the rule shown below.
Port
1
2
3
4
5
6
1
V
V
2
V
V
3
V
V
4
V
V
5
V
V
6
V
V V V V
V
ICPE(config-vlan-ID)# name
[vlan_name]
[vlan_name]
Specify a descriptive name for this
VLAN ID, max 15 characters.
ICPE(config)# vlan isolation up-link-
port [port_list]
[port_list]
To assign uplink ports which will form
a port-based VLAN group with all
other downlink ports seperatedly so to
isolated downlink ports from each
other except from uplink ports.
ICPE(config)# vlan management-
vlan [1-4094] management-port
[port_list] mode [access | trunk |
trunk-native]
[1-4094]
Enter the management VLAN ID.
[port_list]
Specify the management port number.
[access | trunk |
trunk-native]
Specify whether the management port
is in trunk or access mode.
“trunk” mode:
Set the selected ports
to tagged.
“access” mode:
Set the selected ports
to untagged.
“trunk-native” mode:
Set all
untagged traffic travels on the default
Access-VLAN for the trunk-native
