119
0x03
Close
Open
0x04
Counter-Clockwise
Clockwise
0x05
Left
Right
0x06
Reverse
Forward
0x07
Pull
Push
0x08-0x1F
Reserved
Level:
This is used to set a value in a supporting device.
The details of value are shown as below:
Value
Level
State
0 (0x00)
0%
Off
1..99 (0x01..0x63)
Lowest non-zero level .. 100%
On
…
Reserved
Reserved
255 (0xFF)
Restore most recent (non-zero) level.
On
Dimming Duration:
Specify the time that the transition should take from the current value to the new
target value.
Start Level
Up/Down:
This is used for manipulating the primary device functionality. “Up” is to increase level for
Primary Switch Type. “Down” is to decrease level for Primary Switch Type. No Up/Down is to
maintain current level for Primary Switch Type. Click drop-down arrow and pick the designated one.
Start Level:
Specify the initial level of the level change.
Secondary Switch Inc/Dec:
This used for controlling the secondary device functionality. “Increment”
is to Increase level for Secondary Switch Type. “Decrement” is to decrease level for Secondary Switch
Type. “No Inc/Dec” is to maintain current level for Secondary Switch Type. Click drop-down arrow
and pick the designated one.
Secondary Switch Step Size:
Specify the value 0~99 or 255.
Duration:
The dimming rate to use must be calculated to match a transition from 0 to 99 during the
time specified by the Duration box.
Click “START” to send “Multilevel Switch Start Level Change Command” based on the configured
parameter.
Click “STOP” stop the command in process.
3.8.2.12 Meter Settings
This is intended for Z-Wave enabled devices capable of reporting energy measurements in addition to
any main functionality or features e.g. an appliance module reporting the current consumption of the
connected load.
