CTI 2572-A, Installation And Operation Manual

Page: 26 / 130

CTI 2572-A Installation and Operation Guide
18
2.10. Storing Network Parameters in EEPROM
Before you can automatically start the Network Server from EEPROM, you must enter the Module IP
address and other network parameters. The following sections describe the available options.
Entering the Network Parameters via the module Serial Port
You can enter the network parameters using a serially attached PC and a configuration program from
CTI. The CTID
IAG
program used with the 2572 module will work in this application. It may be
downloaded from the CTI web site.
•
Install CTID
IAG
on your computer.
•
Connect the computer to the module serial port using a serial cable wired for RS-232. The serial
cable that you use with your PLC programming software should work properly.
•
Select the COM port and set the baud rate to correspond to the module selection (see Section
2.4.
Setting the 2572-A Option Switches
. S
et the remaining port parameters as follows: Parity =
Odd, Data Bits = 7, and Stop Bits = 1.
•
Under the Commands menu item select S
ET
N
ETWORK
P
ARAMETERS
.
•
Follow the instructions on the screen for setting the network parameters.
Once you have completed this action, you must reset the module for the changes to take effect. The
module will re-start using the parameters you just entered.
Changing Network Parameters using a Web Browser
Point your browser to the main 2572_A Menu page by entering the IP address in the browser URL
field. For example, 192.168.177.55 would point to the web page of the 2572A module with IP
address 192.168.177.55. From the main page, select M
ODULE
C
ONFIGURATION
. Unless you have
bypassed password protection, you will be asked for a User ID and Password. The default User ID
and default Password are both
CONFIG
. When the configuration page is displayed, enter the new IP
address information in the appropriate fields and press the Update Module button.