5-6
Assembly Manual: Undercarriage
Revised 12.2019
Fig 78 - Hoses between hydraulic motors
Fig 79 - 117” Hydraulic hose to valve
26. Attach a 1/2 x 52 inch hose onto the bottom,
inside fitting on the left-side motor
27. Attach a 1/2 x 54 inch hose to the top,
outside fitting, on the same motor.
28. Flatten hoses on top of the axle tube.
- Fit under the hose clamps and tighten.
29. Attach both 52 inch and 54 inch hoses to the
left side of the cushion block, which will sit in
the axle as well.
30. Run a 1/2 x 15 inch hose from the right-side
of the cushion block to the bottom, outside
fitting on the motor.
31. Run a 1/2 x 16 inch hose from the block to
the top, inside fitting of the same motor.
32. Run a 1/2 x 45 inch from the top, outside
port on the cushion block, to the lower fitting
of the #1 (right side) port of the relief valve.
45
62
52
52
15
45
16
62
54
54
Fig 80 - Valve Drawing
62
33. Run a 1/2 x 62 inch from the top, inside port
on the block, to the to the left, inner, rear
port on the mover kit valve.
Fig 81 - Clamp hoses
