6-5
Assembly Manual: Tube
Revised 12.2019
Fig 140 - Undercarriage slide
12. Lift the tube to place the drive box under the
tube.
The hydraulic motor is already attached to
the drive box.
Note:
Position Drive Box so
springs facing discharge.
13. Bolt the Winch Mount Tube Clamp (a) to the
drive box at the hopper end of the tube.
- Do not tighten, yet.
14. Bolt Light Mounting Bracket (b) above the
drive box springs.
- Do not tighten, yet.
EQUIPMENT WEIGHT HAZARD
Use lift equipment rated to hold 2000 lb.
Ensure stands can hold the weight,
and are stable.
OVERHEAD EQUIPMENT HAZARD
Use caution when working under the tube.
15. Lift the entire tube.
16. Place the Hopper and Discharge on stands.
11. Install the Undercarriage Slide on the tube.
- Lift the tube.
- Move the Slide beneath.
- Align cutout in Slide with tube flange.
If necessary, cut the Slide to fit.
- Lay tube on top.
- Place three, 3 inch tube clamps above
Slide tube clamps.
- Add the bolts, but do not tighten.
Fig 141 - Drive box and tube clamps
Fig 142 - Hopper on stands
a
b
Fig 143 - Discharge on stands
