5-12
Assembly Manual: Undercarriage
Revised 12.2019
Fig 103 - Add clamps to lift cable
Fig 104 - Bring cable around mounting plate
Fig 105 - Tighten cable clamps
Fig 106 - Tighten cable clamps
61. At the top of the cylinder, Add 3 clamps to
the cable.
- Route the cable around the support (above
the pulleys), just before the mounting plate.
62. Bring the cable back around the support.
- Thread it back through the three clamps.
IMPORTANT:
Apply U-Bolt over dead end of cable,
live end rests in saddle.
Tighten nuts evenly, alternate from one nut to
the other until recommended torque is reached.
63. Tighten the 1st clamp.
- Give 4 inch of slack cable, below clamp.
64. Slide the 3rd clamp up towards the support.
- Tighten 3rd clamp.
- Position 2nd clamp in the middle and
tighten.
65. Wrap the cable and with electrical tape.
