Continuum Surelite EX 10, Operation And Maintenance Manual

Page: 84 / 114

Continuum Surelite Laser
74 996-0207
4. Position power meter ~3" (7.6 cm) from the exit port so that it will intercept the laser
beam.
5. Locate and identify the horizontal and vertical adjust knobs at the rear of the oscillator.
(See Figure 50.) Observe how a 2 mm Allen key will fit in the slots and allow
adjustment of these controls.
Figure 50 Rear mirror horizontal and vertical controls
6. Perform the System Startup procedure (page 27 ).
Burn paper alignment
This section describes specific procedures for aligning and optimizing oscillator performance.
N
ECESSARY
E
QUIPMENT
•
Kodak Linagraph paper (type 1895, CAT#1986108)
•
clear plastic bags
•
1 metric Allen wrench set
•
Mirror mount adjustment tool
When the Linagraph (or “ burn paper” ) is new it will have a pink emulsion on one side of it.
Expose this side to room light for approximately 30-40 minutes to turn the emulsion to a light
brown color. Once it's this color the paper will give the best representation of the laser beam
profile.