Continuum Surelite EX 10, Operation And Maintenance Manual

Page: 32 / 114

Flow test the system
CAUTION!
Before the first startup of the laser, be sure to review the
entire manual , especially the section beginning on page
77 concerning elimination of free-running.
1. Plug the PCU into the 200-240 V~ power source.
2. On the front of the PCU, flip the red
AC POWER
switch up to the On position (see
page 3-1 for Startup). After
8.8.8.
and the rev #, the panel LED readout should say
oFF .
3. Turn the keyswitch to the On position. After approximately 10 seconds, the pump
will turn on and begin to circulate water through the system.
4. If error code
E02
displays, turn off the keyswitch and repeat the step above.
5. Flow test the system for 5 minutes while checking for water leaks at the rear and
inside the PCU.
6. If no leaks are detected, shut the system down and reinstall the cooling group cover
panel.
Measure total energy
1. On the Error! Reference source not found. on page Error! Bookmark not defined. of
this manual, note the following:
•
FLASHLAMP DISCHARGE VOLTAGE setting
•
Q-SWITCH DELAY setting.
Figure 10 Setup for energy measurement
While referring to Section 3: System Operation on page 27 , steps 1 to 3, verify that the
FLASHLAMP DISCHARGE VOLTAGE and Q-SWITCH DELAY readouts are at QA
indicated settings.
1. Position volume absorbing head power meter in front of exit port of laser bench. Tilt
meter head slightly so that reflections from head do not go back into exit port.
2. Switch the meter to the 10 watt scale.
3. Perform the DAILY STARTUP procedure. See page 27 in Section 3: System
Operation .