Continuum Surelite EX 10, Operation And Maintenance Manual

Page: 47 / 114

Section 3: System Operation
996-0207 37
•
Second harmonic generator (SLD-1 or SLD-2)
•
(3 ea.) 35 mm long M3 Allen bolts
•
Phillips #2 screwdriver
S
TEPS
1. Shut the system down by performing Daily Shutdown Procedure. See page 28 .
2. Remove laser housing cover that is held in place by the 2 Phillips head screws at each
end.
3. Determine proper harmonic generator orientation. See page 39 .
4. Second harmonic (SLD) - adjust knob on top and the SLD output face is toward exit
port.
5. Hold the harmonic generator above the heater PCB and plug the heater cable into an
open 4 pin connector on the heater PCB. Be sure contact is made. See drawing on page
39 .
6. Place three M3 Allen bolts into deeply recessed bolt holes on exit face of the harmonic
generator. Align the harmonic bolt holes to those on the horseshoe shaped bracket and
screw in bolts using a 2.5 mm Allen key.
7. Reinstall laser housing cover.
Installation of SLT or SLF
N
ECESSARY
E
QUIPMENT
•
Phillips #2 screwdriver
•
Third harmonic generator (SLT) or fourth harmonic generator (SLF)
S
TEPS
1. Shut the system down by performing Daily Shutdown Procedure. See page 28 .
2. Remove the laser housing cover that is held on by the 2 Phillips head screws at each end.
3. Determine proper harmonic generator orientation. See page 39 .
•
Third harmonic (SLT) - adjust knob points horizontally to the
sid
e ) and the output
face is toward the exit port.
•
Fourth harmonic (SLF) - adjust knob points horizontally to the
sid
e ) and the output
face is toward the exit port.
4. Hold the harmonic generator above the heater PCB and plug the heater cable into an
open 4 pin connector on the heater PCB. Be sure contact is made. See Figure 20 on
page 39 .
5. Slide the male guide pins (on input face of SLT or SLF) into their female counterparts
located on output face of the second harmonic generator.
6. While holding the SLT or SLF in place, rotate the locking collar clockwise until the
harmonic generator is snugly secured to the second harmonic generator. See page 39 .