Continuum Surelite EX 10, Operation And Maintenance Manual

Page: 29 / 114

Figure 8 Surelite crate
Figure 6 Surelite Crate with top
and front removed
Figure 7 Surelite crate with umbilical
shelf removed
Unpacking Instructions
Crate Inspection
Check the crate for damage before unpacking the laser. If damaged, please notify both the
freight company and Continuum before proceeding
with the installation.
Unpacking
Please read through these instructions before
attempting to unpack the Surelite.
Only a claw hammer or pry bar is needed for prying up
the clamps. Remember to keep the crate after
unpacking for future use. Warranty repairs require that the system be returned shipped in
its original crate.
1. Place the crate near the optical table. Leave enough
space to install the built-in ramp.
2. Remove all clamps but the two holding the
front of the crate.
3. Remove the top of the crate and set it aside.
Carefully release the last two clamps on front of the
crate and set aside. This front side of the crate is
marked “ramp” and will be used in step 9.
4. Remove manual package from umbilical shelf.
The installation section of the manual will be
needed after unpacking is completed. Unwind the
umbilical and drape it over the back end of the
crate.
5. Remove the umbilical shelf.
6. Using the finger hole, pull the foam cover
from the laser bench.
7. Using the hand holds, have two people reach in
and cradle the laser bench. Lift the bench up and out
of the foam enclosure and place it on the table. Do
not
lift the laser up by the umbilical.
8. Remove the 2 boxes containing the Surelite Separation Package (SSP) and
accessories. Place near laser bench. Empty them of all hardware.
9. Take the front section of the crate and use it for
a ramp. Install the ramp by inserting inside lip to fit