TRP1000-4450 Troposcatter C-Band Outdoor Amplifier
Revision 0
Serial-based Remote Product Management
5–15
MN-TRP1000-OD
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for
Command
or Response
to Query
Description of Arguments
(Note that all arguments are ASCII
numeric codes between 48 and 57)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code and
Qualifier)
Response
to Query
(Target to
Controller)
Software
Image
IMG=
1 byte
Command or Query.
Current Active software image,
Where:
1=Bulk Image # 1 currently active
2=Bulk Image # 2 currently active
Examples:
<1/IMG=1’cr’ (instructs the unit to load firmware from image
#1 at the next reset / power up).
<1/IMG?’cr’ (queries the image number that the firmware
loaded during bootup)
Note
: If the user sends the IMG command, and then queries
the IMG value, the numbers may not be equal because
the command tells the firmware which image to boot
from at the next bootup, and the query reports the
image that the firmware booted from on the last bootup.
IMG=
IMG?
IMG*
IMG#
IMG?
IMG=x
(See
description
for details of
arguments)
IP Address
IPA=
18 bytes
Command or Query.
Used to set the IP address and network prefix for the 10/100
BaseT Ethernet management port, in the format:
xxx.xxx.xxx.xxx.yy,
Where:
xxx.xxx.xxx.xxx is the IP address, and
yy is the network prefix (8-30)
Example:
<1/IPG=192.168.001.004.24’cr’
>0001/IPG=’cr’’lf’
Note:
Changing the IP address through the Telnet interface
requires the user to power cycle the unit, and then
restart a new Telnet session with the new IP address.
The IP address typed into the Telnet client software
does not include the range parameter, so it would be:
192.168.1.4.
Default Value: 192.168.001.004.24
IPA=
IPA?
IPA*
IPA#
IPA?
IPA=
xx.xxx.xxx.x
xx.yy
(See
description
of
arguments)