Comtech EF Data CDM-425, Installation And Operation Manual

Page: 363 / 744

CDM-425 Advanced Satellite Modem
Revision 0
Serial Remote Control 8–39 MN-CDM-425
Parameter
Command
(Instruction
& Qualifier)
Length of
Arguments
Description of Arguments
Response to
Command
Query
(Instruction
& Qualifier)
Response to Query
Radius
Server
Password
Type
RAT= 1 byte,
0 or 1
Command or Query.
Sets or returns the RADIUS Server password type in the form x, where
0=PAP
1=CHAP
EXAMPLE: <0/RAT=0
NOTE: Parameter available only through Telnet CLI. Command available at Administrator level only.
RAT=
RAT?
RAT*
RAT#
RAT? RAT=x
(see Description of
Arguments)
Radius
Server Shared
Secret
RAS= Up to 64 bytes Command or Query.
Sets or returns the RADIUS Server shared secret
EXAMPLE: <0/RAS=comtech
NOTE: Parameter available only through Telnet CLI. Command available at Administrator level only.
RAS=
RAS?
RAS*
RAS#
RAS? RAS=xxx…
(see Description of
Arguments)
Precision
Time Protocol
Transport
Mode
PTU= 1 byte Command or Query.
Sets or returns PTP Transport Mode in the form x, where:
0=Multicast
1=Unicast
PTU=
PTU?
PTU*
PTU#
PTU? PTU=x
(see Description of
Arguments)
Precision
Time Protocol
Unicast
Master
PTS= 15 bytes Command or Query.
Sets or returns the PTP Unicast Master IP Address in the form xxx.xxx.xxx.xxx.
PTS=
PTS?
PTS*
PTS#
PTS? PTS=xxx.xxx.xxx.xxx
(see Description of
Arguments)
Precision
Time Protocol
Unicast Sync
Interval
PTY= 2 bytes Command or Query.
Sets or returns the PTP Unicast Master IP Address in the form xx, where:
-6= 64 Messages per second
-5= 32 Messages per second
-4=16 Messages per second
-3=8 Messages per second
-2=4 Messages per second
-1=2 Messages per second
+0=1 Message per second
+1=1 Message every 2 seconds (default value)
PTY=
PTY?
PTY*
PTY#
PTY? PTY=xx
(see Description of
Arguments)
Port
Monitoring
Enable
PME= 1 byte Command or Query.
Sets or returns port monitoring in the form x, where:
0=Disabled
1=Enabled
NOTE: MAC Learning must be enabled to monitor properly.
EXAMPLE: <0/PME=0
PME=
PME?
PME*
PME#
PME? PME=x
(see Description of
Arguments)
Port
Monitoring
Source Port
PMS= 1 byte Command or Query.
Sets or returns the port monitoring source (monitoring) port in the form x, where:
1=Port 1
2=Port 2
3=Port 3
4=Port 4
5=WAN
NOTES:
1) Source port and destination port must be different.
2) WAN (5) monitors Packet Processor traffic if it presents.
EXAMPLE: <0/PMS=1
PMS=
PMS?
PMS*
PMS#
PMS? PMS=x
(see Description of
Arguments)