Comtech EF Data CDM-425, Installation And Operation Manual

Page: 331 / 744

CDM-425 Advanced Satellite Modem
Revision 0
Serial Remote Control 8–7 MN-CDM-425
8.5 Remote Commands and Queries
8.5.1 Table Indexes
NOTES:
1) Index Columns – Where Column ‘C’ =Command, and Column ‘Q’ =Query, columns marked ‘ X ’ designate the instruction code as
Command only , Query only , or Command or Query . Where CODE=XXX , this indicates a priority command.
2) In the tables that follow, the following codes are used in the ‘Response to Command’ column (per Sect. 8.5.5):
= Message ok # Message ok, but unit is not in Remote mode.
? Received ok, but invalid arguments were found.
~ Time out of a pass-through message, either to via EDMAC or to a local
ODU.
^ Message ok, but unit is in Ethernet mode.
Sect. 8.5.2 Tx Parameters
CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE
APP X X 8–15 TCI X X 8–16 TFQ X X 8–13 TMI — X 8–17 TSR X X 8–13
AUP X X 8–15 TCK X X 8–16 TFT X X 8–11 TMR X X 8–13 TTA X X 8–16
DTS X X 8–17 TCR X X 8–11 TIR — X 8–17 TMX X X 8–13 TTC X X 8–17
DTY X X 8–16 TDI X X 8–13 TIT X X 8–10 TPL X X 8–14 TTF — X 8–17
PLI — X 8–16 TDR X X 8–13 TLO X X 8–17 TSC X X 8–14 TXA X X 8–15
REB — X 8–16 TFM X X 8–10 TMD X X 8–11 TSI X X 8–14 TXO X X 8–15
Sect. 8.5.3 Rx Parameters
CODE C Q PAGE
CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE
CODE C Q PAGE
EBA X X 8–23 RCK X X 8–22 RFM X X 8–18 RMD X X 8–19 RSW X X 8–22
ITS X X 8–23 RCR X X 8–19 RFQ X X 8–21 RMI — X 8–24 RTC X X 8–23
ITY X X 8–23 RDI X X5 8–21 RFT X X 8–19 RMR X X 8–22 RTE X X 8–23
RBS X X 8–23 RDR X X 8–21 RIR — X 8–24 RMX X X 8–21 RTF — X 8–24
RCB X — 8–23 RDS X X 8–22 RIT X X 8–18 RSI X X 8–22
RCI X X 8–22 REE X X 8–24 RLO X X 8–24 RSR X X 8–21