Comtech EF Data CDM-425, Installation And Operation Manual

Page: 229 / 744

CDM-425 Advanced Satellite Modem
Revision 0
Ethernet-based Remote Product Management 7–5 MN-CDM-425
7.4 Telnet Interface
Chapter 8. SERIAL-BASED REMOTE PRODUCT MANAGEMENT
Chapter 9. TELNET COMMAND-LINE INTERFACE (CLI) OPERATION
Comtech EF Data provides a Telnet interface for the purpose of equipment monitor and control
(M&C) using either the standard remote control protocol or, when the optional IP Packet
Processor is installed and enabled, the Telnet Command Line Interface (CLI).
7.4.1 Using the Telnet Interface for Standard Remote Control Protocol
Do these steps to use Windows Command-line to access the Telnet Interface:
1. Click [Start] on the Windows taskbar, and then click the Run... icon (or, depending on
Windows OS versions prior to Windows 95, click the MS-DOS Prompt icon from the
Main Menu ).
2. Next, open a Command-line window…
•
For Windows 95 or Windows 98, type “ command ” (or, for any Windows OS versions
later than Windows 98, type “ cmd ” or “c ommand ”):
•
Alternately, from [Start], select All Programs > Accessories > Command Prompt.
3. From the Command-line prompt (c:\>), type “ telnet xxx.xxx.xxx.xxx 107 ” (where
‘ xxx.xxx.xxx.xxx ’ is the modem’s Ethernet Traffic/Management IP Address).
4. Access requires login at the Administrator and Read/Write User Access Levels. Once
you log in as the Administrator, you may issue remote commands and queries over the
CDM-425 Telnet Interface.