Commander Connect Owners Manual
117
Configuring ISDN on your system
ISDN programming options, set by your Commander technician during installation, are available
to configure ISDN on your system. It is recommended that you do not change the existing
settings.
To access ISDN configuration options
•
From the Programming Station, press the PROGRAM Key
•
Press the Scroll Down Key (
) until ‘System programming’ is displayed
•
Select ‘System programming’
•
Enter the System Programming Password and select ‘Lines’
•
Press the Scroll Down Key (
) until ‘ISDN Programming’ is displayed
•
Select ‘ISDN programming’.
Follow on with the procedures below, as required.
To configure ISDN Accesses as Point-to-Point or Point-to-Multipoint
•
Select ‘P->P’ or P->MP’ (Point to Point or Point to Multipoint)
•
The ISDN Access menu will be presented. Point-to-Point Accesses are denoted by a
♦
. Point-to-Multipoint accesses are denoted by a
◊
. Select an Access to change its
setting.
Press the Hands-free Key to finish programming.
Note
: Changing this setting will cause the system to reset (warm reset). This will cause all calls
to be disconnected.
Note:
Your
Commander
technician will ensure your ISDN Accesses are correctly configured
as P-P or P-MP. If the setting does not match the ISDN network setting you will be unable to
receive and make calls.
To configure ISDN Accesses as T or S interfaces
•
Select ‘T or S interface’
•
The ISDN Access menu will be presented. Accesses configured as a T interface are
denoted by a
♦
. Those configured as an S interface are denoted by a
◊
. Select an
Access to change its setting.
Press the Hands-free Key to finish programming.
To configure an ISDN Access to work with a PABX
•
Select ‘ISDN PABX’
•
Select the required Access.
Press the Hands-free Key to finish programming.
