19
System parameters
Presence of expansions
GSM
PSTN
Network card (Ip)
Audio
Domotics
Intercom
IP Options
Options
Check presence of connection to internet
Enable DHCP (obtain IP address automatically)
IP Address
Subnet mask
Gateway
Primary DNS
Secondary DNS
Host name
192.168. 1 .230
255.255.255. 0
192.168. 1 . 1
192.168. 1 . 1
0 . 0 . 0 . 0
IP?
Status
Absent
1
2
ID Description
Pal/Ip 1
Pal/Ip 2
Area 2
Area 3
Area 4
Area 5
Area 6
Area 7
Area 8
Display technical alarms
Area
Pal-Ip video module
Activat
Input...
Pal-Ip parameters programming
Pal-Ip video module to update
Current IP address (Pal-Ip video module)
Current netmask (Pal-Ip video module)
New IP address
New netmask
Gateway
Address acquisition mode
Close
Ping
Ping
Alarm panel
Final IP address (control unit)
Ping
Run
0 . 0 . 0 . 0
192.168. 1 .234
192.168. 1 . 1
255.255.255. 0
192.168. 1 .230
Static address
0 . 0 . 0 . 0
3.1.5 Phone App
√ SafeManager software installed on a PC, version 2.2.0 or higher.
√ VEDO10, VEDO34 or VEDO68 control panel, version 2.2.0 or higher.
√ IP network card Art. VEDOIP, version 2.2.0 or higher.
√ PAL IP module Art. VEDOCCTV , version 2.2.0 or higher (required if you want to view cameras via the APP).
√ Camera connected to the PAL IP module (required if you want to view cameras via the App).
√ Internet connection (for remote App usage).
1. In "System Parameters", enable the IP network card.
2. In "IP Options", make sure that the IP address of the network card for the module is compatible with the router network.
3. In "Pal-Ip Video Module", activate the PAL IP module (if present).
4. In "Pal-Ip Video Module", press "Assign new IP to the module..." to set a compatible IP address and send programming with "run" (see
Configuration of a Pal/IP module,
"3.11.3 Pal/IP video module" on page 54
).
5. In "Pal-Ip video module", in the section "Cameras installed", select how many cameras are connected and to which areas they refer; in the "Video
acquisition mode” field select PAL.
6. In the "Phone App" section, activate how many Apps on mobile devices will be able to connect to the control panel (max 8), configure the device
by setting the following parameters and set the notifications you wish to receive using the section "Detailed events" (see
"3.12.5 Detailed events"
on page 64
).
SYSTEM REQUIREMENTS:
HOW TO PROCEED
In the project there must be no active or isolated App devices [Reg. 44]
To obtain certification, there must be no Pal/Ip Modules in the project [Reg. 104]
Summary of Contents for VEDO 2.6 Series
Page 99: ...99...
