Maintenance
98
C2500CB-OM-EN-16
9. Check the sealing surfaces and threads on the filter mount and the new filter
element and clean if necessary.
10. Apply a thin film of clean hydraulic oil to the O-ring on a new suction filter
element.
11. Screw the new filter element on to the filter mount until it is hand tight only. DO
NOT over tighten the filter. Use a genuine OEM component.
12. Start the truck and check around the filter for leaks. Repeat the check when the
hydraulic oil has reached operating temperature.
13. Top up the hydraulic oil if necessary (see section 5.5 Checking Hydraulic Oil
Level on page 49).
14. Dispose of waste oil and used filter elements in compliance with statutory
legislation.
Return Filter
The return filter element must be replaced after the first 100 hours of operation and
then at regular intervals in accordance with the maintenance schedule.
To change the return filter element:
1. Park the truck in a designated service
area
in
accordance
with
the
recommended parking procedure.
2. Lower the mast fully and tilt the mast
fully forward.
3. Switch off the engine and remove the
key from the ignition.
4. Open the bonnet from the right hand
side of the truck to gain access to the
return filter (
A
).
5. Clean and dry the area around the return
filter thoroughly to prevent any
contamination
from
entering
the
hydraulic system.
6. Unscrewing the return filter cover (
B
).
7. Lift out the filter element (
C
) and bowl
(
D
) using the handle on the element.
8. Remove the used filter element (
C
) from
the bowl (
D
). Collect the used element
and any escaping oil in a suitable
container and dispose of in compliance
with statutory legislation.
9. Apply a thin film of clean hydraulic oil to
the O-ring on the bottom of a new filter
element and fit into the bowl.
A
B
C
D
