Maintenance
83
C2500CB-OM-EN-16
Perform maintenance on the LP gas system as described in the relevant engine
maintenance manual in conjunction with the procedures described in sections
6.7 LP
Gas Inline Filter (If Fitted)
and
6.8 LP Gas Pressure Regulator
. Contact your local
Combilift partner for assistance if required.
6.7
LP Gas Inline Filter (If Fitted)
The LP gas inline filter is mounted on the sliding LP gas bottle carrier, which is located
below the seat on the left hand side of the truck.
Changing the LP Gas In-line Filter:
1. Park the truck on level ground in a well ventilated area and ensure no external
ignition sources are present.
2. Lower the mast fully and tilt the mast fully forward.
3. Close the valve on the LPG bottle fully by turning it clockwise.
4. Run the engine until it cuts out (to burn off any remaining fuel in the lines).
5. Turn the ignition key switch to the ‘0’ (off) position and remove the key.
6. Isolate the battery by turning the battery isolator key switch anticlockwise.
7. Open the anti-luce fastener (
A
) on the LPG bottle carrier.
8. Slide the LPG bottle carrier tray (
B
) out
fully.
9. Unscrew the hose coupling (
C
) from the
LPG bottle. Place the hose coupling
carefully in a safe position.
10. Open the LPG bottle latch (
D
) (or ratchet
strap – if fitted), then remove the bottle
from the carrier and place carefully in a
safe location.
11. Unscrew the hose (
E
) from the used
filter element (
F
).
12. Unscrew and remove the used filter
element (
F
).
13. Clean the threads on the hose (
E
) and
the fitting (
G
).
14. Take a new filter. Ensure the threads are
clean, dry and free from oil and grease.
Apply B577 pipe seal to the threads of
the new filter immediately before
fitting.
15. Fit the new filter. Allow at least 20
minutes for the B577 pipe seal to cure.
16. Slowly open the valve on the LP gas
cylinder.
A
D
B
C
E
F
G