Maintenance
77
C2500CB-OM-EN-16
Note
Clean and dry the area around all components concerned thoroughly before
commencing work.
Observe safety regulations when handling oils and avoid skin contact.
Do not pour fluids into the ground, down a drain or into a stream, pond or
lake. Observe relevant environmental protection regulations when disposing
of used oil and filters.
Note
See Appendix A for ‘California Engine Emission Control Warranty
Statement’ regarding owners ‘Warranty Rights and Obligations’.
See Appendix B for General Engine Warranty Statement.
The lubricating oil change interval must be halved if at least one of the following
conditions applies:
Constant ambient temperature below -10 °C (14 °F) or lube oil
temperature below 60 °C (84 °F).
Sulphur content in diesel fuel of >0.5 weight %.
If the lubricating oil change intervals are not reached within a year, the oil
should be changed at least once a year.
Changing Engine Oil & Filter
The engine oil and filter must be replaced at regular intervals in accordance with the
maintenance schedule.
When changing the oil always change the oil filter and
vice versa.
Diesel Engine Oil & Filter Change Procedure
1. Park the truck in a designated service
area (ground must be level).
2. Lower the mast fully and tilt the mast
fully forward.
3. Switch off the engine and wait until all
parts are cool enough to touch.
4. If the engine is cold run it for 5 minutes
to warm the oil. This will help it to flow.
5. Open the bonnet from the right hand
side of the truck.
6. Remove the access panel (
A
) from the
right hand side of the truck.
A
D
C
B
