Cisco Sx350, Cli Manual

Page: 851 / 1323

MLD Snooping Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 850
42
42.10 ipv6 mld snooping vlan static
To register a IPv6-layer Multicast address to the bridge table, and to add statically
ports to the group, use the ipv6 mld snooping vlan static command in Global
Configuration mode. To return to the default, use the no form of this command.
Syntax
ipv6 mld snooping vlan
vlan-id
static
ipv6-address
[interface
interface-list
]
no ipv6 mld snooping vlan
vlan-id
static
ipv6-address
[interface
interface-list
]
Parameters
•
vlan-id —Specifies the VLAN.
•
ipv6-address
—Specifies the IP multicast address
•
interface interface-list —(Optional) Specifies list of interfaces. The
interfaces can be from one of the following types: Ethernet port or
Port-channel.
Default Configuration
No Multicast addresses are defined.
Command Mode
Global Configuration mode
User Guidelines
Static multicast addresses can only be defined on static VLANs.
You can execute the command before the VLAN is created.
You can register an entry without specifying an interface.
Using the no command without a port-list removes the entry.
Example
switchxxxxxx(config)# ipv6 mld snooping vlan 1 static FF12::3 gi1
1