Cisco Sx350, Cli Manual

Page: 1279 / 1323

Virtual Local Area Network (VLAN) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1278
67
User Guidelines
Forwarding of packets based on their MAC address requires setting up groups of
MAC addresses and then mapping these groups to VLANs.
Up to 256 MAC addresses (host or range) can be mapped to one or many
MAC-based VLAN groups.
Example
The following example creates two groups of MAC addresses, sets a port to
general mode and maps the groups of MAC addresses to specific VLANs.
switchxxxxxx(config)#
vlan database
switchxxxxxx(config-vlan)#
map mac 0000.1111.0000 32 macs-group 1
switchxxxxxx(config-vlan)# map mac 0000.0000.2222 host macs-group 2
switchxxxxxx(config-vlan)#
exit
switchxxxxxx(config)#
interface gi14
switchxxxxxx(config-if)# switchport mode general
switchxxxxxx(config-if)#
switchport general map macs-group 1 vlan 2
switchxxxxxx(config-if)#
switchport general map macs-group 2 vlan 3
67.24 switchport general map macs-group
vlan
Use the switchport general map macs-group vlan Interface Configuration mode
command to set a MAC-based classification rule. Use the no form of this command
to delete a classification rule.
Syntax
switchport general map macs-group
group
vlan
vlan-id
no switchport general map macs-group
group
Parameters
•
group —Specifies the group number (range: 1–2147483647)
•
vlan-id
—Defines the VLAN ID associated with the rule.