Cisco Sx350, Cli Manual

Page: 739 / 1323

iSCSI QoS Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 738
32
•
From initiator to target sub-flow—The sub-flow is classified by the
Destination TCP port defined by the
tcp-port
argument and by the
configured Destination IP address, if the
ip-address
argument is configured.
•
From target to initiator sub-flow—The sub-flow is classified by the Source
TCP port defined by the
tcp-port argument and by the configured Source IP
address, if the ip-address argument is configured.
Up to 8 iSCSI flows are supported.
Use the iscsi flow default command, to restore the iSCSI default configuration.
For the same TCP port you can use either the iscsi flow
tcp-port
command or a
few iscsi flow tcp-port ip-address commands with different IP addresses.
Use the no iscsi flow tcp-port ip-address command, to delete the iSCSI flows
defined by the iscsi target port
tcp-port ip-address
command.
Use the no iscsi flow
tcp-port
command, to delete the iSCSI flows defined by the
iscsi flow tcp-port command.
To delete a default iSCSI flow, use the no iscsi flow tcp-port command.
To delete all default iSCSI flows, use the no iscsi flow default command.
To delete all iSCSI flows (including the default ones), use the no iscsi flow
command.
Example
The following example defines four pair of iSCSI flows:
switchxxxxxx(config)#
no iscsi flow default
switchxxxxxx(config)# iscsi flow 1200
switchxxxxxx(config)#
iscsi flow 1201 1.1.1.1
switchxxxxxx(config)#
iscsi flow 1201 1.1.1.10
switchxxxxxx(config)# iscsi flow 1201 101.12.21.410
32.3 iscsi qos
To define the quality of service profile applying to iSCSI flows, use the iscsi qos
command in Global Configuration mode. To restore the default configuration, use
the no form of the command.