Cisco Sx350, Cli Manual

Page: 525 / 1323

IP Routing Protocol-Independent Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 524
25
Examples
Example 1—The following example shows how to route packets for network
172.31.0.0 to a router at 172.31.6.6 using mask:
switchxxxxxx(config)# ip route 172.31.0.0 255.255.0.0 172.31.6.6 metric 2
Example 2—The following example shows how to route packets for network
172.31.0.0 to a router at 172.31.6.6 using prefix length :
switchxxxxxx(config)# ip route 172.31.0.0 /16 172.31.6.6 metric 2
Example 3—The following example shows how to reject packets for network
194.1.1.0:
switchxxxxxx(config)# ip route 194.1.1.0 255.255.255.0 reject-route
Example 4—The following example shows how to remove all static routes to
network 194.1.1.0/24:
switchxxxxxx(config)# no ip route 194.1.1.0 /24
Example 5—The following example shows how to remove one static route to
network 194.1.1.0/24 via 1.1.1.1:
switchxxxxxx(config)# no ip route 194.1.1.0 /24 1.1.1.1
25.4 ip routing
To enable IP routing, use the ip routing command in global configuration mode. To
disable IP routing, use the no form of this command.
Syntax
ip routing