Introduction
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
32
1
If access is via a Telnet or SSH connection, ensure that the following conditions are
met before using CLI commands:
•
The switch has a defined IP address.
•
Corresponding management access is enabled.
•
There is an IP path such that the computer and the switch can reach each
other.
Using HyperTerminal over the Console Interface
The switch’s RJ45 port provides a direct connection to a computer’s serial port
using a standard DB-9 null-modem or crossover cable. After the computer and
switch are connected, run a terminal application to access the CLI.
The terminal emulator must be configured to databits=8 and parity=none.
Click Enter twice, so that the device sets the serial port speed to match the PC's
serial port speed.
When the
CLI
appears, enter cisco at the
User Name
prompt and then enter
cisco
for the
Password
prompt.
The
switchxxxxxx#
prompt is displayed. You can now enter CLI commands to
manage the switch. For detailed information on CLI commands, refer to the
appropriate chapter(s) of this reference guide.
Using Telnet over an Ethernet Interface
Telnet provides a method of connecting to the CLI over an IP network.
To establish a telnet session from the command prompt, perform the following
steps:
Summary of Contents for Sx350
Page 1: ...Cisco Sx350 Ph 2 2 5 Devices Command Line Interface Reference Guide CLI GUIDE ...
Page 26: ...25 Cisco Sx350 Ph 2 2 5 Devices Command Line Interface Reference Guide 1 ...
Page 237: ...CDP Commands Cisco Sx350 Ph 2 2 5 Devices Command Line Interface Reference Guide 236 8 ...
Page 975: ...RADIUS Commands Cisco Sx350 Ph 2 2 5 Devices Command Line Interface Reference Guide 974 48 ...
