Cisco Sx350, Cli Manual

Page: 526 / 1323

IP Routing Protocol-Independent Commands
525 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
25
no ip routing
Parameters
This command has no arguments or keywords.
Default Configuration
IP routing is enabled.
Command Mode
Global Configuration mode
User Guidelines
Use the command to enable IP Routing.
Example The following example enables IP routing
switchxxxxxx(config)# ip routing
25.5 show ip route
To display the current state of the routing table, use the show ip route command in
user EXEC or privileged EXEC mode.
Syntax
show ip route [address
ip-address
{
mask
[longer-prefixes]} [static | rejected | icmp |
connected]
Parameters
•
address
ip-address
—IP address about which routing information should be
displayed.
•
mask —The value of the subnet mask.
•
longer-prefixes—Specifies that only routes matching the IP address and
mask pair should be displayed.
•
connected—Displays connected routes.
•
icmp—Displays routes added by ICMP Direct.