Cisco Sx350, Cli Manual

Page: 757 / 1323

Link Aggregation Control Protocol (LACP) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 756
35
35.2 lacp system-priority
To set the system priority, use the lacp system-priority Global Configuration mode
command. To restore the default configuration, use the no form of this command.
Syntax
lacp system-priority value
no lacp system-priority
Parameters
value—Specifies the system priority value. (Range: 1–65535)
Default Configuration
The default system priority is 1.
Command Mode
Global Configuration mode
Example
The following example sets the system priority to 120.
switchxxxxxx(config)# lacp system-priority 120
35.3 lacp timeout
To assign an administrative LACP timeout to an interface, use the lacp timeout
Interface (Ethernet) Configuration mode command. To restore the default
configuration, use the no form of this command.
Syntax
lacp timeout {long | short}
no lacp timeout
Parameters
•
long—Specifies the long timeout value.