5
Installation
10/100 16-Port VPN Router
Chapter 3
Place the wall-mount slots over the screws and slide
5.
the Router down until the screws fit snugly into the
wall-mount slots.
Rack-Mount Placement
The Router includes two brackets and eight screws for
mounting on a standard-sized, 19-inch high rack. Observe
the following guidelines:
Elevated Operating Ambient
•
If installed in a closed
or multi-unit rack assembly, the operating ambient
temperature of the rack environment may be greater
than room ambient. Therefore, consideration should
be given to installing the equipment in an environment
compatible with the maximum ambient temperature
(Tma) specified by the manufacturer.
Reduced Air Flow
•
Installation of the equipment
in a rack should be such that the amount of air flow
required for safe operation of the equipment is not
compromised.
Mechanical Loading
•
Mounting of the equipment in
the rack should be such that a hazardous condition is
not achieved due to uneven mechanical loading.
Circuit Overloading
•
Consideration should be given
to the connection of the equipment to the supply
circuit and the effect that overloading of the circuits
might have on overcurrent protection and supply
wiring. Appropriate consideration of equipment
nameplate ratings should be used when addressing
this concern.
Reliable Earthing
•
Reliable earthing of rack-mounted
equipment should be maintained. Particular attention
should be given to supply connections other than
direct connections to the branch circuit (e.g., use of
power strips).
To rack-mount the Router in any standard 19-inch rack,
follow these instructions.
Place the Router on a hard flat surface with the front
1.
panel faced towards your front side.
Attach a rack–mount bracket to one side of the Router
2.
with the supplied screws and secure the bracket
tightly.
1
2
3
4
5
6
7
8
9
10
11
12
13
1
2
3
4
5
6
7
10/100 16-Port VPN Router
LAN/Act
LAN/Act
Internet/Act
RV016
9
10
12
13
1
2
3
4
5
6
7
Internet
Internet
DMZ
11
RV016 10/100 VPN Router
Attach the Brackets
Repeat step 2 to attach the other bracket to the
3.
opposite side.
After the brackets are attached to the Router, use
4.
suitable screws to securely attach the brackets to any
standard 19-inch rack.
1
2
3
4
5
6
7
8
9
10
11
12
13
1
2
3
4
5
6
7
10/100
16-Port VPN
Router
LAN/Act
LAN/Act
Internet/Act
RV016
9
10
12
13
1
2
3
4
5
6
7
Interne
t
Internet
DMZ
11
RV016 10/100 VP
N Router
Mount in Rack
Cable Connections
To connect network devices to the Router, follow these
instructions:
Before you begin, make sure that all of your hardware
1.
is powered off, including the Router, computers,
switches, and cable or DSL modem.
Connect one end of an Ethernet network cable to one
2.
of the numbered local ports (white print). Connect the
other end to an Ethernet port on a network device,
such as a computer or switch.
Repeat this step to connect more computers or other
network devices to the Router.
Connect to LAN Port 1
