Chapter 4
Advanced Configuration
9
10/100 16-Port VPN Router
The Summary table shows the settings of the selected
port, including Type, Interface, Link Status, Port Activity,
Priority, Speed Status, Duplex Status, Auto negotiation,
and VLAN.
Port 1 Information
For the selected port, the statistics table shows this
information: number of packets received, number of
packet bytes received, number of packets transmitted,
number of packet bytes transmitted, and number of
packet errors.
To update the on-screen information, click
Refresh
. To
exit this screen, click
Close
.
Network Setting Status
LAN IP
It shows the current LAN IP address of the Router,
as seen by internal users on the network, and it hyperlinks
to the LAN Setting section on the
Network
screen of the
Setup tab.
WAN IP
This shows the current WAN IP addresses of
the Router, as seen by external users on the Internet
and hyperlinks to the WAN Setting section on the
Setup
>
Network
screen. By default, the Router provides two
WAN ports. On the
Setup > Network
screen, you can set up
additional WAN ports.
If the port is set to Obtain an IP automatically, two buttons,
Release and Renew, will be available. Click
Release
to
release the IP address, and click
Renew
to update the
DHCP Lease Time or get a new IP address. If the WAN
port is set to PPPoE or PPTP, two buttons, Connect and
Disconnect, will be available.
DMZ IP
This shows the DMZ IP address, as seen by
external users on the Internet and hyperlinks to the DMZ
Setting section on the
Setup >
Network
screen.
Mode
It shows the Router’s Working Mode (Gateway or
Router), and it hyperlinks to the Dynamic Routing section
on the
Setup > Advanced Routing
screen.
DNS
It shows all DNS server IP addresses and hyperlinks
to the WAN Connection Type settings on the
Setup >
Network
screen.
Bandwidth Management
It shows the Bandwidth
Management settings of the Router’s WAN port(s) and
hyperlinks to the
System Management > Bandwidth
Management
screen.
DDNS
It shows the DDNS settings of the Router’s WAN
port(s) and hyperlinks to the
Setup > DDNS
screen.
DMZ Host
It shows the DMZ private IP address and
hyperlinks to the
Setup > DMZ Host
screen. The default is
Disabled
.
Firewall Setting Status
SPI (Stateful Packet Inspection)
It shows the status
(On/Off) of the SPI setting and hyperlinks to the
Firewall >
General
screen.
DoS (Denial of Service)
It shows the status (On/Off) of
the DoS setting and hyperlinks to the
Firewall > General
screen.
Block WAN Request
It shows the status (On/Off) of
the Block WAN Request setting and hyperlinks to the
Firewall > General
screen.
VPN Setting Status
VPN Summary
It hyperlinks to the
VPN > Summary
screen.
Tunnel(s) Used
It shows the number of VPN tunnels
used.
Tunnel(s) Available
It shows the number of VPN tunnels
available.
Current Connected (The Group Name of GroupVPN1)
users
It shows the number of users. (If the GroupVPN
feature is disabled, the message, “No Group VPN was
defined”, is displayed.)
Current Connected (The Group Name of GroupVPN2)
users
It shows the number of users.
PPTP Server
It shows the status of the PPTP Server
feature.
Log Setting Status
It hyperlinks to the
Log > System Log
screen of the Log
tab.
If you have not set up the e-mail server on the Log tab,
the message, “E-mail cannot be sent because you have
